News

Sign up today to get the latest news and updates from EPC on new product announcements, applications work, and much more. Sign up for EPC email updates.

EPC and Analog Devices Collaborate to Deliver up to 2 MHz Switching Frequency for the Highest Density DC-DC Converters Using GaN FETs

EPC and Analog Devices Collaborate to Deliver up to 2 MHz Switching Frequency for the Highest Density DC-DC Converters Using GaN FETs

EPC and Analog Devices introduce reference design using a new Analog controller fully optimized to drive EPC GaN FETs. The combination of the new Analog LTC7890 synchronous GaN buck controller with ultra-efficient eGaN® FETs from EPC (Efficient Power Conversion) enables up to 2 MHz switching frequency for high power density and low-cost DC-DC Conversion.

EL SEGUNDO, Calif.—  March, 2022 — EPC announces the availability of the EPC9160, a dual output synchronous buck converter reference design board operating at 2 MHz switching frequency that converts an input voltage of 9 V to 24 V to a 3.3 V or 5 V output voltage and delivers up to 15 A continuous current for both outputs. Thanks to the high switching frequency the converter size is very small, only 23 mm x 22 mm for both outputs, and the inductor height is only 3 mm.

The high density and thickness of the design plus the 2 MHz switching frequency make this solution ideal for automotive console applications, where 2 MHz switching frequency is preferred, and computing, industrial, consumer, and telecom power systems requiring small size and a very thin profile. eGaN® FETs  provide the fast switching, high efficiency and small size that can meet the stringent power density requirements of these leading-edge applications.

The EPC9160 reference design uses the EPC2055 enhancement-mode GaN FET and the LTC7890 two-phase analog buck controller with integrated GaN drivers.

  • The LTC7890 100 V low Iq, dual, 2-phase synchronous step-down controller is fully optimized to drive EPC eGaN FETs and integrates a half bridge driver and smart bootstrap diode. It offers optimized near-zero deadtime or programmable deadtime and programmable switching frequency up to 3 MHz. The quiescent current of 5 uA (VIN = 48 V, VOUT = 5 V, CH1 only)  enables very low standby power consumption and excellent light load efficiency.
  • The EPC2055 40 V eGaN FETs offers 3 mOhm max RDS(on), 6.6 nC QG, 0.7 nC QGD, 1.3 nC QOSS and zero QRR in a super small 2.5 mm x 1.5 mm footprint and can deliver up to 29 A continuous current and 161 A peak current. The excellent dynamic parameters allow very small switching losses at 2 MHz switching frequency.

The efficiency of the EPC9160 is greater than 93 % for 5 V output and 24 V input . In addition to light load operating mode and adjustable dead time, the board offers UVLO, Over-current protection, and power good output.

Alex Lidow, CEO of EPC commented, “GaN FETs ultra-low switching losses enable operations above 2 MHz, with the new analog controller customers now have a full ecosystem able to work above 2 MHz. We are delighted to work with Analog Devices to combine the benefits of their advanced controllers with the performance of GaN to provide customers with the highest power density and low component count solutions that increases the efficiency, increases power density, and reduces system cost”

“The Analog Device’s LTC7890 is designed to fully exploit the high performance of EPC’s eGaN FETs for high power density solutions” said Tae Han, Sr. Product Marketing Manager at Analog