In this installment of the ‘How to GaN’ series we will discuss a new family of eGaN FETs that is keeping Moore’s Law alive with significant gains in key switching figures of merit that widen the performance gap with the power MOFET in high frequency power conversion.

EEWeb
By: Alex Lidow
October, 2014

EPC9118 demonstrates size reduction and efficiency enhancement for power conversion readily achieved using high frequency switching eGaN^® FETs for supply voltages up to 48 V or more.

EL SEGUNDO, Calif.—October 2014 — Efficient Power Conversion Corporation (EPC) introduces the EPC9118, a fully functional buck power conversion demonstration circuit. This board is a 30 V-60 V input to 5 V, 20 A maximum output current, 400 kHz buck converter. It features the EPC2001 and EPC2015 enhancement-mode (eGaN^®) field effect transistors (FETs), as well as the LTC3891 buck controller. This buck converter design is ideal for distributed power solutions in telecom, industrial, and medical applications.

The market for SiC and GaN power semiconductors is expected to grow at 63 percent CAGR between 2011 and 2017, reaching around $500 million, according to The Information Network, a US market research company.

Compound Semiconductor
October, 2014
Read the article

EPC2025 GaN power transistor offers power systems designers a 300 V power transistor capable of 2ns rise times for high frequency DC-DC converters and medical diagnostic instruments.

EL SEGUNDO, Calif. — September 2014 — EPC announces the EPC2025, a 300 V power transistor for use in applications requiring high frequency switching in order to achieve higher efficiency and power density. Applications enhanced by higher switching speeds include ultra-high frequency DC-DC converters, medical diagnostic equipment, power inverters, and LED lighting.

Gallium nitride (GaN) is one of the technologies that could well displace silicon MOSFETs in the next generation of power transistors. As silicon approaches its performance limits, GaN devices conduct better and switch faster. In this short podcast, Alex Lidow talks about the differences between GaN and silicon power devices.

Power Electronic TIPS
Press play button to listen to interview

EPC2100 GaN power transistor offers power systems designers a solution that increases efficiency and power density for complete buck converter systems approaching 93% at 10 A, and over 90.5% at 25 A when switching at 500 kHz and converting from 12 V to 1.2 V.

EL SEGUNDO, Calif. — September 2014 — EPC announces the EPC2100, the first commercially available enhancement-mode monolithic GaN transistor half bridge. By integrating two eGaN power FETs into a single device, interconnect inductances and the interstitial space needed on the PCB are eliminated. This increases both efficiency (especially at higher frequencies) and power density, while reducing assembly costs to the end user’s power conversion system.

On September 3^rd IEEE PELS will offer a webinar by Dr. Johan Strydom discussing the contribution of gallium nitride power transistors to meet the demanding system bandwidth requirements of envelope tracking applications.

EL SEGUNDO, Calif.— August 2014 — An Efficient Power Conversion Corporation (EPC) expert on the application of gallium nitride transistors in envelope tracking power circuit design will conduct a one-hour webinar sponsored by the IEEE Power Electronics Society (PELS) on September 3^rd from 11:00 AM to 12:00 AM (EDT).

This article presents hard-switching buck converter results switching at 10 MHz and gives a breakdown of the converter losses. It will demonstrate the unmatched high frequency performance capability currently available using eGaN^® FETs and also highlight the current limitations to pushing to even higher switching frequencies.

EEWeb
By: Alex Lidow
August, 2014

Intent on flooding power device markets with GaN-on-silicon FETs, Alex Lidow, EPC, talks to Compound Semiconductor about future market opportunities.

Compound Semiconductor
July, 2014
Read the article

Long talked about, wide bandgap gallium nitride-on-silicon (GaN-on-Si) transistors are now commercially available. They are being touted for replacing silicon-based MOSFETs, which are turning out to be inefficient for many high-performance power supply designs. Recently, several suppliers of GaN-on-Si-based HEMTs and FETs have emerged in the marketplace, among them Efficient Power Conversion (EPC). To expedite the evaluation of eGAN FETs for power supply designs transitioning from silicon MOSFETs to eGaN FETs, EPC has released several development boards in the last few years.

By Ashok Bindra
Digi-Key Article Library
July 15, 2014
Read the article

Superior characteristics of eGaN^® FETs, such as low output capacitance, low input capacitance, low parasitic inductances, and small size make them ideal for increasing efficiency in highly resonant, Rezence (A4WP) compliant, wireless power transfer systems.

EL SEGUNDO, Calif.—July 2014 — Efficient Power Conversion Corporation (EPC) today announces the immediate availability of a complete demonstration wireless power transfer kit. The 40 V (EPC9111) or 100 V (EPC9112) wireless kits have three components:

eGaN^® power transistors continue to raise the bar for power conversion performance. Lower on-resistance, lower capacitance, higher current, and superior thermal performance enable power converters with greater than 98% efficiency.

To tweet this news, copy and paste http://bit.ly/EPCXLPR1407 to your Twitter handle with #GaNFET

EL SEGUNDO, Calif.—July 2014 — Efficient Power Conversion Corporation (EPC) announces the introduction of six new-generation power transistor products and corresponding development boards. Ranging from 30 V to 200 V, these products provide significant reduction in R_DS(on) greatly increasing their output current capability in applications such as high power density DC-DC converters, Point-of-Load (POL) converters, synchronous rectification in DC/DC and AC/DC converters, motor drives, LED lighting, and industrial automation.

With high-voltage GaN devices close to commercialization, manufacturers can, at last, look forward massive market growth.

Compound Semiconductor
July, 2014
Read the article

This installment will address an eGaN^® FET module designed as a way for power conversion systems designers to easily evaluate the exceptional performance of gallium nitride transistors.

EEWeb
By: Alex Lidow
June, 2014

The superior characteristics of eGaN^® FETs, such as low output capacitance, low input capacitance, low parasitic inductances, and small size make them ideal for increasing efficiency in highly resonant, Rezence (A4WP) compliant, wireless power transfer systems.

EL SEGUNDO, Calif.—June, 2014 — Efficient Power Conversion Corporation (EPC) today announce the introduction of demonstration boards for wireless power transfer in an innovative high performance topology; Zero Voltage Switching (ZVS) Class-D. The EPC9506 and EPC9507 amplifier (source) boards utilize the high frequency switching capability of EPC gallium nitride transistors to facilitate wireless power systems with greater than 75% efficiency.

Overall, 2020 could see an estimated device market size of almost $600M, leading to approximately 580,000 x 6” wafers to be processed. Ramp-up will be quite impressive starting in 2016, at an estimated 80% CAGR through 2020, based upon a scenario where EV/HEV begins adopting GaN in 2018-2019. The power supply/PFC segment will dominate the business from 2015-2018, ultimately representing 50% of device sales. At that point, automotive will then catch-up.

Yole Development
June, 2014
Read More

Gallium Nitride (GaN) based power devices are rapidly being adopted due to their ability to operate at frequencies and switching speeds beyond the capability of Silicon power devices.

Power Electronics Europe
By: Alex Lidow, Ph.D., Johan Strydom, Ph.D., David Reusch, Ph.D.
June, 2014

Dr. Glaser will be creating benchmark power converter designs and assisting customers in the use of eGaN FETs^® for high frequency, high performance power conversion systems

EL SEGUNDO, Calif.—June 2014 — Efficient Power Conversion Corporation (EPC) is proud to announce that Dr. John Glaser has joined the EPC engineering team as Director, Applications Engineering.

According to the latest report from Yole Développement, the GaN power industry is set for significant growth in the future.

Compound Semiconductor
June 12, 2014
Read the article

Yole Développement interviewed Dr. Alex Lidow, CEO and co-founder of Efficient Power Conversion (EPC).

Yole Développement
June, 2014
Read the Interview