EPC introduces the 100 V, 2.2 mΩ EPC2071 GaN FET, offering designers a significantly smaller and more efficient device than silicon MOSFETs for high-performance, space-constrained applications.
EL SEGUNDO, Calif. — May 2022 — Efficient Power Conversion Corporation, the world’s leader in enhancement-mode gallium nitride (eGaN®) power FETs and ICs, expands the selection of low voltage, off-the-shelf gallium nitride transistors with the introduction of the EPC2071 (1.7 mΩ typical, 100 V) GaN FET.
The EPC2071 is ideal for applications with demanding requirements for high power density performance including 48 V – 54 V input DC-DC for new servers and artificial intelligence. Lower gate charges, QGD, and zero reverse recovery losses enable high-frequency operations of 1 MHz and beyond and high efficiency in a tiny 10.2 mm2 footprint for state-of-the-art power density.
The EPC2071 is ideal for BLDC motor drives, including e-bikes, e-scooter, robots, drones, and power tools. The EPC2071 is 1/3rd the size of a silicon MOSFET with the same RDS(on), QG is 1/4th that of the MOSFET, and the dead time can be reduced from 500 ns to 20 ns to optimize motor plus inverter efficiency and reduce acoustic noise.
The EPC2071 is footprint compatible with EPC’s prior Generation 4 family of products: EPC2021, EPC2022, EPC2206. The Generation 5 improvement in Area x RDS(on) gives the EPC2071 the same on-resistance as the prior generation with a 26% smaller size.
“The EPC2071 makes the ideal switch for the primary side of the LLC DC-DC converter from 40 V – 60 V to 12 V- 5V. This 100-volt device offers improved performance and cost compared with previous-generation 100 V GaN FETs allowing designers to economically improve efficiency and power density”, according to Alex Lidow, EPC’s co-founder and CEO. “These parts are also suitable for telecom and server power supplies, and solar applications. Additionally, EPC2071 is less expensive than comparable silicon devices and in stock!”
Reference Design
The EPC9174 reference design board is a 1.2 kW, 48 V input to 12 V output LLC converter. It features the EPC2071 for the primary side full bridge. The EPC9174 enables 1 MHz switching frequency and 1.2 kW of power in a small 22.9 mm x 58.4 mm x 10 mm size (power density 1472 W/in3). The peak efficiency is 97.3% at 550W and the full load efficiency of 96.3% at 12 V, delivering 100 A output.
Price and Availability
The EPC2071 eGaN FET is priced at 1K u/reel at $3.81 each
The EPC9174 development board is priced at $498.00/each
Both the EPC2071 and EPC9174 demonstration board are available for immediate delivery from Digi-Key at https://www.digikey.com/en/supplier-centers/epc&