EL SEGUNDO, Calif. — December 2020 — BrightLoop Converters has greatly reduced the size, cost and improved reliability of its latest BB SP DC-DC buck converters thanks to Efficient Power Conversion Corporation’s (EPC) EPC2029 enhancement-mode gallium nitride (eGaN^®) FET transistors. By switching from silicon (Si) transistors to gallium nitride (GaN), BrightLoop was able to increase the switching frequency of their design from 200 kHz to 600 kHz, while keeping the same efficiency. This design change increased the power density of the solution by a factor of approximately two and this resulted in lower cost by enabling the implementation of a smaller enclosure.

EPC’s EPC2029 is an 80 V, 48 A eGaN^® FET featuring a 1 mm ball pitch. The wider pitch allows for placement of additional and larger vias under the device to enable high current carrying capability despite the extremely small 2.6 mm x 4.6 mm footprint.

The EPC2152 ePower™ Stage enables higher performance and smaller solution size for high power density, low-cost DC-DC conversion demonstrated in the EPC9151 power module.

EL SEGUNDO, Calif.— December, 2020 — EPC announces the availability of the EPC9151, a 300 W bidirectional DC-DC voltage regulator in the in the very small 16^th brick format which is just 33 mm x 22.9 mm (1.3 x 0.9 in). The EPC9151 power module features Microchip’s dsPIC33CK digital signal controller (DSC) with the EPC2152 ePower™ Stage integrated circuit from EPC to achieve greater than 95% efficiency in a 300 W 48 V to/from 12 V converter design.  Additional phases can be added to this scalable 2-phase design to further increase power.

Gallium nitride power device technology enables a new generation of power converters in space operating at higher frequencies, higher efficiencies, and greater power densities than everachievable before. GaN power devices can also exhibit superior radiation tolerance compared with Silicon MOSFETs depending upon their device design.

Power Electronics Europe
December, 2020
Read article

Wide bandgap (WBG) semiconductors such as silicon carbide (SiC) and gallium nitride (GaN) are the new frontline in power conversion, and that takes design engineers into a whole new frequency spectrum, as well as power density and form factor opportunities.

EDN Editorial Advisory Board
December, 2020
Listen to Interview

Efficient Power Conversion Corporation (EPC), the world’s leader in enhancement-mode gallium nitride on silicon (eGaN^®) power FETs and ICs, has won the Contributor of the Year award of the prestigious World Electronics Achievement Awards (WEAA) 2020 for Dr. Alex Lidow, CEO and co-founder of Efficient Power Conversion.

The WEAA scheme honors products, companies and individuals that have made outstanding contributions to the innovation and development of the electronics industry worldwide. A committee comprising of ASPENCORE global senior industry analysts and online users from Asia, the US and Europe select the winners. ASPENCORE is the largest electronics industry media and SaaS group in the world featuring media titles including EE Times and EDN.

EPC introduces 170 V, 6.8 milliohm EPC2059 eGaN^® FET, offering designers a device that is smaller, more efficient, more reliable, and lower cost than currently available devices for high performance 48 V synchronous rectification.

EL SEGUNDO, Calif. — November 2019 — Efficient Power Conversion Corporation, the world’s leader in enhancement-mode gallium nitride on silicon (eGaN) power FETs and ICs, advances the performance capability while lowering the cost of off-the-shelf gallium nitride transistors with the introduction of the EPC2059 (6.8 mΩ, 170 V) eGaN FET.  This device is the latest in a family of 100 V – 200 V solutions suitable for a wide-range of power levels and price points. They are designed to meet the increasing demands of 48 V – 56 V server and data center products as well as an array of consumer power supply applications for high end computing, including gaming PCs, LCD/LED TVs, and LED lighting.

Stefan Werkstetter appointed as New Director of Sales for EMEA to focus on assisting customers in the adoption of eGaN^® FETs and Integrated Circuits for applications including DC-DC, lidar, motor control, and other leading-edge power conversion systems

EL SEGUNDO, Calif. — November 2020 — To support the continued adoption of gallium nitride (GaN) FETs and Integrated Circuits in the European market, Efficient Power Conversion Corporation (EPC) is pleased to announce the appointment of Stefan Werkstetter as Director, Sales EMEA.

GaN technology has seen significant improvements and has reached an optimal cost for MOSFET replacement. Starting in 2017, the adoption rate of GaN in 48-Vin DC-DC converters began to take on important connotations in the market. Various topologies, such as multi-phase and multi-level bucks are offering new solutions with greater efficiency to cover the energy demands of the IT and automotive markets.

Power Electronics News
November, 2020
Read article

Gallium nitride FETs have continued to gain traction in many power electronic applications, but GaN technology is still in the early part of its life cycle. While there is much room to improve basic FET performance figures of merit an even more promising avenue is the development of GaN power ICs.

Bodo’s Power Systems
November, 2020
Read article

The ultimate aim of Artificial Intelligence is to provide machines the ability to operate autonomously. One such area which is projected to grow exponentially over the next decade is Autonomous Vehicles. With Artificial Intelligence coupled with the rapid advances in electronics and computer technology, the word driverless will soon take over the roads.

AI Time Journal
October, 2020
Read article

THIEF RIVER FALLS, Minnesota, USA – Digi-Key Electronics, the leading global electronic components distributor, announced that it has partnered with Efficient Power Conversion Corporation (EPC) to host a webinar on how to harness the power of eGaN FETS and ICs for motor drives. The webinar will take place on October 28 at 8 a.m. PST.

Register for the Harness the Power of GaN for Smaller, Lighter, More Precise Motor Drives webinar at EPC’s webinar page

Two solutions for high power density DC-DC conversion using ultra-efficient eGaN^® FETs from EPC (Efficient Power Conversion) enable highly efficient solutions for ultra-thin laptops, displays, high-end gaming systems and other physically thin consumer electronics.

EL SEGUNDO, Calif.— October, 2020 — EPC announces the availability of the EPC9148 and EPC9153 demonstration boards for 48 V DC-DC conversion.  The EPC9153 is a 250 W, extremely thin, power module using a simple, low-cost synchronous buck configuration delivering a 98.2% peak efficiency with a maximum component height of 6.5 mm.  The EPC9148 utilizes a multilevel topology enabling a maximum component height less than 4 mm, while maintaining a 98% peak efficiency.

Discrete power transistors, whether silicon-based or GaN-on-silicon, are entering their final chapter. GaN-on-Si integrated circuits offer higher performance in a smaller footprint with significantly reduced cost and less engineering required. This article details how the ascent of GaN is redefining power conversion.

Bodo’s Power Systems
October, 2020
Read article

These new generation 100 V eGaN^® FETs are ideal for 48-V_OUT synchronous rectification, class-D audio, infotainment, and lidar.

EL SEGUNDO, Calif.— September, 2020 — EPC, the world’s leader in enhancement-mode gallium nitride on silicon (eGaN) power FETs and ICs, advances the performance capability while lowering the cost of off-the-shelf gallium nitride transistors with the introduction of EPC2218 and EPC2204 100 V eGaN FETs.  The applications for these leading-edge devices include synchronous rectification, class-D audio, infotainment systems, DC-DC converters (hard-switched and resonant), and lidar for autonomous cars, robotics, and drones.

Standard qualification testing for semiconductors typically involves stressing devices at-or-near the limits specified in their data sheets for a prolonged period of time, or for a certain number of cycles, with the goal of demonstrating zero failures. By testing parts to the point of failure, an understanding of the amount of margin beyond the data sheet limits can be developed, but more importantly, an understanding of the intrinsic failure mechanisms of the semiconductor can be found.

Bodo’s Power Systems
September, 2020
Read article Read more

Silicon power MOSFETs have not kept pace with the evolutionary changes in the power electronics industry, where factors such as efficiency, power density, and smaller form factors are the main demands of the community. Silicon MOSFETs have reached their theoretical limits for power electronics, and with board space at a premium, power system designers need alternatives. Gallium nitride (GaN) is a high-electron-mobility transistor (HEMT) semiconductor that is adding real value in emerging applications.

EETimes
August, 2020
Read article

These new generation 200 V eGaN^® FETs are ideal for 48 V_OUT synchronous rectification, class-D audio, solar microinverters and optimizers, and multilevel, high-voltage AC/DC converters

EL SEGUNDO, Calif.— August, 2020 — EPC, the world’s leader in enhancement-mode gallium nitride on silicon (eGaN) power FETs and ICs, advances the performance capability while lowering the cost of off-the-shelf gallium nitride transistors with the introduction of the EPC2215 and EPC2207 200 V eGaN FETs.  The applications for these leading-edge devices include class D audio, synchronous rectification, solar MPPTs (maximum power point tracker), DC-DC converters (hard-switched and resonant), and multilevel high voltage converters.

Gallium nitride is helping the transition from internal combustion engines to electric and smart cars.

Power Systems Design
July/August 2020 Issue
Read article

In this inaugural episode, guests are Alex Lidow, CEO of Efficient Power Conversion Corp., and Dinesh Ramanathan, co-CEO of NexGen Power Systems. EPC and NexGen both have expertise with gallium nitride technology and GaN power devices. EETimes speaks with both about the technology and about the market for GaN power devices.

EETimes
August, 2020
Listen to podcast

Gallium nitride (GaN) power devices have been in volume production since March 2010 and have established a remarkable field-reliability record. An automotive application using GaN power devices in high volume is lidar (light detection and ranging) for autonomous vehicles. Lidar technology provides information about a vehicle’s surroundings, thus requiring high accuracy and reliability to ensure safety and performance. This article will discuss a novel testing mechanism developed by Efficient Power Conversion (EPC) to test eGaN devices beyond the qualification requirements of the Automotive Electronics Council (AEC) for the specific use case of lidar.

eeNews Europe
July 30, 2020
Read article