Efficient Power Conversion (EPC) expands its family of radiation-hardened (rad-hard) gallium nitride (GaN) products for power conversion solutions with two new 40 V devices rated at 62 A and 250 A to address critical spaceborne and other high-reliability applications.

EL SEGUNDO, Calif.— July 2023 — EPC announces the introduction of two new 40 V rated radiation-hardened GaN FETs.EPC7001 is a 40 V, 4 mΩ, 250 A_Pulsed, rad-hard GaN FET in a small 7 mm² footprint. EPC7002 is a 40 V, 14.5 mΩ, 62 A_Pulsed, rad-hard GaN FET in a tiny 1.87 mm² footprint.  Both devices have a total dose radiation rating greater than 1,000K Rad(Si) and SEE immunity for LET of 83.7 MeV/mg/cm² with V_DS up to 100% of rated breakdown. These new devices, along with the rest of the Rad Hard family, are offered in a chip-scale package.  Packaged versions are available from EPC Space.

Transient voltage overshoot is a common phenomenon in GaN high electron mobility transistors (HEMTs) under high slew rate switching conditions. The dynamic parametric instability under such stress is a critical concern for GaN applications. This work, for the first time, accurately characterized the evolution of dynamic on-resistance (R_DS(on)) in GaN HEMTs under repetitive voltage overshoot up to billions of switching cycles. The dynamic R_DS(on) increase was found to be the dominant device degradation under overvoltage switching. Such findings were obtained from a high-frequency, repetitive, unclamped inductive switching (UIS) test with active temperature control and accurate in-situ R_DS(on) monitoring. A physics-based model was proposed to correlate the dynamic R_DS(on) drift with the peak overvoltage, and a good agreement with experimental data was achieved. This model was further used to project the lifetime of GaN HEMTs. For 100 V rated GaN HEMTs switched under 100 kHz and 120 V spikes, the model projects less than 10% dynamic R_DS(on) shift over 25 years of continuous operation. This work addresses the major concerns of overvoltage switching reliability of GaN HEMTs and provides new insights of the electron trapping mechanism.

IEEE Xplore
Ruizhe Zhang, Ricardo Garcia, Robert Strittmatter, Yuhao zhang, Shengke Zhange
Read article (IEEE subscription required)

On July 3^rd, 2023, China’s Ministry of Commerce announced it would put in place certain restrictions on the exporting of gallium and germanium, among other materials, starting in August of this year. EPC’s wafer technology is ‘GaN-on-Si’, although the amount of gallium in each device is miniscule. There are significant sources of gallium available worldwide and EPC’s needs are relatively small, we expect no short or long-term interruption of supply.

Gallium Nitride (GaN) heterojunction field effect power transistors in the 15 V to 350 V range have shown to give significant advantages over silicon in efficiency, size, speed, and cost in applications such as power conversion, motor drive, and pulsed light for lidar. GaN integration provides numerous system benefits for many high frequency applications. GaN integration is just beginning, and the benefits are assured to increase over time.

Bodo’s Power Systems
June, 2023
Read article

EPC, a leader in enhancement-mode gallium-nitride (GaN) FETs and ICs, delivered multiple technical presentations on GaN technology and showcased applications at PCIM Europe 2023 in Nuremburg. We spoke with the company's Founder and CEO, Alex Lidow, about the power industry and how it's being impacted by GaN devices.

Electronic Design
May, 2023
View video

In this episode of Spirit: Behind the Screen, Spirit Electronics CEO Marti McCurdy chats with EPC’s CEO Alex Lidow and Marketing Director Renee Yawger about the progress of GaN. They discuss GaN’s performance under high radiation as well as the extensive testing, failure modes and device lifespan detailed in EPC’s Phase 15 reliability report. With the full potential of GaN still to be explored and new EPC products releasing frequently, including new half-bridge drivers, low-side drivers and full power stage, GaN is especially useful in New Space and commercial space applications.

Spirit: Behind the Screen
Listen to podcast

Case Spotlights Next-Gen Tech Replacing Silicon

(El Segundo, California)—Efficient Power Conversion Corporation (EPC), the global leader in gallium nitride (GaN) technology, today filed complaints in federal court and in the U.S. International Trade Commission (ITC) asserting four patents of its foundational patent portfolio against Innoscience (Zhuhai) Technology Company, Ltd. and its affiliates (collectively, Innoscience).  These patents cover core aspects of the design and manufacturing process of EPC’s proprietary enhancement-mode gallium nitride power semiconductor devices.  These patents encompass innovations that enabled GaN-based power devices to mature from a research project to a mass-producible high-volume alternative to silicon-based transistors and integrated circuits with GaN devices having higher efficiency, smaller size, and lower cost. 

Monolithic GaN integration has matured to the point that complex circuits such as a half bridge gate driver with various features can now be realized. This article will cover DC-to-DC and BLDC motor drive application examples that benefit from monolithic half-bridge integration.

Power Electronics News
May, 2023
Read article

The EPC9186 GaN-based inverter reference design enhances motor system performance, range, precision, and torque for high power applications.

EL SEGUNDO, Calif.— May, 2023 — EPC announces the availability of the EPC9186, a 3-phase BLDC motor drive inverter using the EPC2302 eGaN^® FET. The EPC9186 supports a wide input DC voltage ranging from 14 V to 80 V. The high-power capability of the EPC9186 supports applications such as electric scooters, small electric vehicles, agricultural machinery, forklifts, and high-power drones.

Modern solar panels are demanding increasingly higher power density and longer operating lifetimes. Solar applications including power optimizers and panels with built-in microinverters are becoming the prevailing trend for an increasing number of solar customers, where low voltage GaN power devices (V_DS < 200 V) are extensively used.

Bodo’s Power Systems
May, 2023
Read article

Gallium nitride (GaN) transistors and ICs have the best attributes to satisfy BLDC inverter needs. The superior switching capability of GaN helps to remove dead time and increase PWM frequency to obtain unmatched sinusoidal voltage and current waveforms for smoother, silent operation with higher system efficiency

Power Systems Design
May, 2023
Read article

EPC and Analog Devices introduce a reference design using a new Analog controller fully optimized to drive EPC GaN FETs and achieving greater than 96.5% efficiency.

EL SEGUNDO, Calif.— July, 2022 — EPC announces the availability of the EPC9158, a dual output synchronous buck converter reference design board operating at 500 kHz switching frequency that converts an input voltage of 48 V - 54 V to a regulated 12 V output and delivers up to 25 A per phase or 50 A total continuous current. The combination of the new Analog LTC7890 synchronous GaN buck controller with ultra-efficient GaN FETs from EPC enables a highly efficient solution in a small footprint for high power density applications. The solution achieves 96.5% efficient at 48 V to 12 V and 50 A continuous current.

EPC’s GaN Experts will be available during PCIM Europe 2023, showcasing the latest generation of GaN FETs and ICs in a wide variety of real-world applications.

EL SEGUNDO, Calif. — April 2023 — — EPC, the world’s leader in enhancement-mode gallium nitride FETs and ICs,will be delivering multiple technical presentations on GaN technology and showcasing applications at PCIM Europe 2023 in Nuremburg, 09 – 11 May (see detailed schedule below). In addition, the company will demonstrate its latest eGaN^® FETs and ICs in a large variety of customer end products in Hall 9, Stand 318.

In this episode of The EEcosystem Podcast, our guest is Dr. Alex Lidow, CEO and co-founder of Efficient Power Conversion. In this episode, we will find out more about Alex and learn about MOSFETs and the rise of GaN. How did MOSFETs grow so quickly? What technologies are driving GaN adoptions and why. We will also discuss the potential obstacles to GaN adoption. This and many more questions will be answered as we go along! Listen to this episode to learn more!

April, 2023
View video

This article discusses the advantages of GaN-based power stages and introduces a sample device from EPC, implemented in a half-bridge topology. It explains how to use associated development kits to quickly get started on a project. In the process, designers will learn how to measure the parameters of a BLDC motor and operate it in sensorless field orientation control (FOC) with minimal programming effort using Microchip Technology’s motorBench Development Suite.

Digi-Key Electronics
April, 2023
Read article

Efficient Power Conversion (EPC) expands its family of radiation-hardened (rad-hard) gallium nitride (GaN) products for power conversion solutions with two new devices rated at 100 V and 200 V to address a multitude of critical spaceborne and other high-reliability .

EL SEGUNDO, Calif.— April 2023 — EPC announces the introduction of two new radiation-hardened GaN FETs. The EPC7020 is a 200 V, 11 mΩ, 170 A_Pulsed, rad-hard GaN FET in a small 12 mm² footprint. The EPC7003 is a 100 V, 30 mΩ, 42 A_Pulsed, rad-hard GaN FET in a tiny 1.87 mm² footprint.  Both devices have a total dose radiation rating greater than 1,000K Rad(Si) and SEE immunity for LET of 83.7 MeV/mg/cm² with V_DS up to 100% of rated breakdown. These new devices, along with the rest of the Rad Hard family, EPC7019, EPC7014, EPC7004, EPC7018, EPC7007, are offered in a chip-scale package, the same as the commercial eGaN^® FET and IC family.  Packaged versions will be available from EPC Space.

Efficient Power Conversion (EPC) publishes Phase-15 Reliability Report adding to the extensive knowledge base on GaN reliability and mission robustness.

EL SEGUNDO, Calif.— March 2023 — EPC announces the publication of its Phase-15 Reliability Report, documenting continued work using test-to-fail methodology and adding specific reliability metrics and predictions for real world applications including solar optimizers, lidar sensors, and DC-DC converters.

Efficient Power Conversion (EPC) expands its family of footprint compatible ePower™ Stage ICs to boost power density and simplify design for different power requirements in DC-DC applications, motor drives, and class-d audio amplifiers.

EL SEGUNDO, Calif.— March 2023 — EPC announces the introduction of two new 100 V power stage ICs rated at 15 A (EPC23104) and 25 A (EPC23103). The two devices join the 100 V 35 A power stage IC EPC23102 offered by EPC.

With Electronic Power Steering (EPS), the hydraulic system is replaced with an electric motor that aids the driver only when needed. Its digital assistance control can be modified online to adapt to driving conditions. There are, however, several design constraints to consider. One is that the driver does not want to lack the haptic feedback from the tires, especially when a vehicle is large, such as a truck. Other constraints are determined by safety regulations, particularly for automatic guided vehicles. These constraints require adopting an efficient, accurate and redundant system. Gallium nitride technology helps the designers in all these areas.

Power Electronics News
March, 2023
Read article

EL SEGUNDO, Calif.—  March 2023 – Efficient Power Conversion (EPC), the world’s leader in enhancement-mode gallium nitride FETs and ICs, has teamed up with SHARGE Technology (SHARGE) to design a 67 W USB PD charger with a power display screen. The Retro 67 fast charger uses EPC’s 100 V GaN FET, EPC2218, which can deliver 231 A pulsed current in a tiny footprint of 3.5 mm x 1.95 mm offering designers a significantly smaller, more efficient device than silicon MOSFET for USB PD fast chargers.

EPC2218 provides SHARGE’s All-GaN fast charger with higher efficiency, state-of-the-art power density and lower system cost.